Elk Heights is a separated section of the LT Murray network of Green Dot roads surrounded on all sides by private property. It is very important that we stay on the legal marked Green Dot roads, not only to keep the government from closing them, but also to avoid issues with the local landowners.

These Green Dot roads are pretty typical for Green Dots – some areas are bumpy, some are smooth, and there are some deep ruts. Most of them have only mild elevation changes.
The area is full of nice looking forest, great smells, and a relaxed riding area that is good for the family.

Get details including directions, staging areas, maps, and difficulty levels in the UTV Guide to WA State.

Similar Posts

  • Republic Area

    This area contains a network of forest service roads in the Colville NF which are legal for all vehicles, and a few actual trails. The N and SW regions can be accessed by driving your ORV right out of Republic. However, the SE region, which has the best scenery, requires that you trailer your ORV…

  • Wenas Wildlife Area

    This area provides a mountain forest landscape, with tall windy ridge lines, and twisty canyons full of trees. You can ride all day here in a large loop with a little bit of backtracking and see canyons, rock formations, and rolling hills. But by the time you’re done, you’ll be pretty tired because some of…

  • Naches Pass Trail

    In the mid-1800s, a road was made from Walla Walla to Fort Steilacoom through Naches Pass. But it was too difficult for early settlers. It has stayed available for motorized recreation, but has fairly restrictive seasons due to the elevation, and the effects of motorized vehicles on trails (especially when the snow melts). Lower Naches…

  • Liberty

    The Liberty area hosts a series of 4×4 trails in steep mountain terrain. When it is dry, the dirt can be loose and slippery in places. When wet, the mud will make it treacherous in most areas. There are lots of off-camber situations and steep hill climbs, often combined for extra fun. Seasonal closure in…

Leave a Reply